Dell Precision M2400 (Mid 2008) - Manual (Page 90)

Hard drive problems
Run Check Disk —
Windows XP:
1. Click Start and click My Computer.
2. Right-click Local Disk C:.
3. Click Properties® Tools® Check Now.
4. Click Scan for and attempt recovery of bad sectors and click Start.
Windows Vista:
1. Click Start and click Computer.
2. Right-click Local Disk C:.
3. Click Properties® Tools® Check Now.
The User Account Control window may appear. If you are an administrator on the computer, click Continue; otherwise, contact your administrator to
continue the desired action.
4. Follow the instructions on the screen.
IEEE 1394 Device Problems
Ensure that the cable for the IEEE 1394 device is properly inserted into the device and into the connector on the computer
Ensure that the IEEE 1394 device is enabled in system setup — For more information on using the system setup program, see the Dell™ Technology Guide
on your computer or at support.dell.com.
Ensure that the IEEE 1394 device is recognized by Windows —
Windows XP:
1. Click Start and click Control Panel.
2. Under Pick a Category, click Performance and Maintenance® System® System Properties ® Hardware® Device Manager.
Windows Vista:
1. Click Start ® Control Panel® Hardware and Sound.
2. Click Device Manager.
If your IEEE 1394 device is listed, Windows recognizes the device.
If you have problems with a Dell IEEE 1394 device —
Contact Dell Support.
If you have problems with an IEEE 1394 device not provided by Dell — Contact the IEEE 1394 device manufacturer.
Lockups and Software Problems
The computer does not start up
Check the diagnostic lights —
See Power Problems .
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
NOTE: Your computer supports only IEEE 1394a standard.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.