Dell Precision M2400 (Mid 2008) - Manual (Page 43)

Replacing the Camera and Microphone Assembly
1. Slide the cable connector of the camera/microphone cable into the connector on the camera/microphone assembly.
2. Close the lever on the connector on the camera/microphone assembly.
3. Angle in and align the camera/microphone assembly with the notch on the display cover.
4. Tighten the M2 x 3-mm screw that secures the camera/microphone assembly to the display cover.
5. Replace the display bezel (see Replacing the Display Bezel (E6400 and M2400) or Replacing the Display Bezel (E6400 ATG) ).
6. Replace the display assembly (see Replacing the Display Assembly (E6400 and M2400) or Replacing the Display Bezel (E6400 ATG) ).
7. Replace the hinge covers (see Replacing the Hinge Covers ).
8. Replace the bottom of the base assembly (see Replacing the Bottom of the Base Assembly ).
9. Follow the procedures in After Working on Your Computer .
Removing the Latch Hook Assembly
1. Follow the instructions in Before Working on Your Computer .
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly ).
3. Remove the hinge covers (see Removing the Hinge Covers ).
4. Remove the display assembly (see Removing the Display Assembly (E6400 and M2400) or Removing the Display Assembly (E6400 ATG) ).
5. Remove the display bezel (see Removing the Display Bezel (E6400 and M2400) or Removing the Display Bezel (E6400 ATG) ).
6. Remove the M2.5 x 5-mm screw, and angle the latch hook assembly out of the display cover.
5 camera/microphone cable
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1 camera/microphone assembly 2 notch on display cover
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.