Dell Precision M2400 (Mid 2008) - Manual (Page 7)

Back to Contents Page
Battery Latch Assembly
Dell™ Latitude™ E6400 and E6400 ATG and
Mobile Workstation Precision™ M2400 Service Manual
Removing a Battery Latch Assembly
Replacing the Battery Latch Assembly
There are two battery latches, a left and a right, and each latch uses a unique latch assembly. The spring, screw, and release buttons are the same for the left
and right battery latches.
The removing and replacing procedures are primarily the same for the right and the left battery latch. The differences are noted for the instructions that are
different for the right and left battery latches.
Removing a Battery Latch Assembly
1. Follow the instructions in Before Working on Your Computer .
2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly ).
3. Remove the hard drive (see Removing the Hard Drive ).
4. Remove the modular drive (see Removing the Modular Drive ).
5. Remove the hinge covers (see Removing the Hinge Covers ).
6. Remove the heatsink assembly (see Removing the Processor Heatsink Assembly ).
7. Remove the display assembly (see Removing the Display Assembly (E6400 and M2400) or Removing the Display Assembly (E6400 ATG) ).
8. Remove the LED cover (see Removing the LED Cover ).
9. Remove the keyboard (see Removing the Keyboard ).
10. Remove the right speaker grill (see Removing the Right Speaker Grill/Fingerprint Reader Assembly ).
11. Remove the palm rest assembly (see Removing the Palm Rest Assembly ).
12. Remove the card cage (see Removing the Card Cage ).
13. Remove the system board (see Removing the System Board Assembly ). Do not remove the wireless mini-cards, memory modules, or processor from the
system board.
14. Remove the modem (see Removing the Modem ).
15. Remove the RJ-11 modem connector (see Removing the RJ-11 Modem Connector ).
16. Remove the I/O card (see Removing the I/O Card ).
17. Remove the M2 x 3-mm screw from the alignment bracket, and remove the battery latch assembly.
18. Remove the spring from the alignment bracket and set it aside until the assembly is ready to be reinstalled.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTICE: The spring is not secured to the alignment bracket and can be easily misplaced. When removing the battery latch assembly, place the
spring in a secure location until the assembly is ready to be reinstalled.