Dell POWEREDGE M1000E - Manual (Page 150)

122 Web Tools Administrator’s Guide
53-1001772-01
Zoning management
9
DRAFT: BROCADE CONFIDENTIAL
If the FCS policy is activated in the fabric, zoning can be administered only from the primary FCS
switch. If the selected switch has an Advanced Zoning license installed, but is not the primary FCS
switch, the Zone Admin option is displayed, but not activated.
You must be logged into the switch using a user name with one of the following roles associated
with it to make changes to the zoning: zoneAdmin, admin, or fabricAdmin. All other roles allow only
a view or read-only access. Most of the zoning operations are disabled in read-only mode.
A snapshot is taken of all the zoning configurations at the time you launch the Zone Administration
window; this information is not updated automatically by Web Tools. To update this information,
refer to
“Refreshing Zone Administration window information” on page 124.
When you log in to a virtual switch, or select a virtual switch using the drop-down list under Fabric
Tree section in the Switch Explorer window, only the ports that are associated with the Virtual
Fabric ID you selected are displayed in the member selection list, as shown in
Figure 37 . You can
use the Add Other button to add ports of other switches in the fabric.
FIGURE 37 Zone Administration window
ATTENTION
Any changes you make in the Zone Administration window are held in a buffered environment and
are not updated in the zoning database until you save the changes. If you close the Zone
Administration window without saving your changes, your changes are lost. To save the buffered
changes you make in the Zone Administration window to the zoning database on the switch, refer to
“Saving local zoning changes” on page 124.