Dell POWEREDGE M1000E - Manual (Page 65)

Web Tools Administrator’s Guide 37
53-1001772-01
Configuring a syslog IP address
3
DRAFT: BROCADE CONFIDENTIAL
3. Click Netstat Performance.
4. Select the Auto Refresh check box to automatically refresh the statistics details.
Clear the check box to disable auto refresh.
5. When enabled, enter the interval time in seconds in the Auto-Refresh Interval field.
The statistics details are automatically refreshed, based on the configured time interval.
Configuring a syslog IP address
The syslog IP represents the IP address of the server that is running the syslog process. The syslog
daemon reads and forwards system messages to the appropriate log files or users, depending on
the system configuration. When one or more IP addresses are configured, the switch forwards all
error log entries to the syslog on the specified servers. Up to six servers are supported. Refer to
Fabric OS Administrator’s Guide for more information on configuring the syslog daemon.
Use the following procedure to configure a syslog IP address.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the Network tab.
3. In the Syslog IP’s Configuration section, in the New IP field, enter an IP address in either IPv4
or IPv6 format.
4. Click Add.
The new IP address displays in the Syslog IP area.
5. Click Apply.
Removing a syslog IP address
Use the following procedure to remove a syslog IP address.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the Network tab.
3. Select a syslog IP in the table and click Remove.
You can click Clear All to remove all of the syslog IP addresses from the table.
4. Click Apply.