Dell POWEREDGE M1000E - Manual (Page 296)

268 Web Tools Administrator’s Guide
53-1001772-01
Enabling and disabling a LAG
19
DRAFT: BROCADE CONFIDENTIAL
1. Select the CEE Interfaces tab on the Port Administration panel.
2. Under the CEE Interface Explorer, select the port you want to enable or disable.
3. Select the General tab.
This tab is normally pre-selected. You can follow either of the following options to enable or
disable the interface:
• Click Enable Interface or Disable Interface to enable or disable the interface, as desired.
• Click Edit Configuration to open the CEE Edit Configuration dialog box. Select Enable or
Disable for the Status field to enable or disable the interface.
Enabling and disabling a LAG
To enable or disable a LAG, perform the following steps.
1. Select the CEE tab on the Switch Administration panel.
2. Select the Link Aggregation tab.
3. Click Add.
The LAG Configuration dialog box displays.
4. Change the Status to Administratively Up or Administratively Down.
Enabling and disabling LLDP
To enable or disable LLDP on a CEE interface, perform the following steps.
1. Select the CEE Interfaces tab on the Port Administration panel.
2. Under the CEE Interface Explorer, select the port.
3. Select the General tab.
4. Click Edit Configuration.
The CEE Edit Configuration dialog box displays.
5. For the LLDP Status option, select Enable or Disable.
Enabling and disabling QoS priority-based flow control
Priority-based flow control (PFC) can be used to control network congestion. PFC can be used to
selectively pause lower priority traffic classes to ensure that high priority and delay-sensitive traffic
are not affected by network congestion. For example, if a large storage transfer is monopolizing the
network and causing congestion, PFC can be used to pause the storage transfer so other traffic
may use the network.
To enable or disable PFC, perform the following steps.
1. Select the CEE tab on the Switch Administration panel.
2. Select the QoS tab.