Dell POWEREDGE M1000E - Manual (Page 69)

Web Tools Administrator’s Guide 41
53-1001772-01
Switch configuration
3
DRAFT: BROCADE CONFIDENTIAL
Changing the switch name
Switches can be identified by IP address, domain ID, World Wide Name (WWN), or switch names.
Names must begin with an alphabetic character, but otherwise can consist of alphanumeric,
hyphen, and underscore characters. The maximum number of characters is 30, unless FICON
mode is enabled. When FICON mode is enabled, the maximum number of characters is 24.
NOTE
Some system messages identify a switch service by the chassis name. If you assign meaningful
chassis names and switch names, system logs are easier to use.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Select the Switch tab.
3. Enter a new name in the Name field and click Apply.
Changing the switch domain ID
Although domain IDs are assigned dynamically when a switch is enabled, you can request a
specific ID to resolve a domain ID conflict when you merge fabrics.
Use the following procedure to change the switch domain ID.
1. Open the Switch Administration window as described in “Opening the Switch Administration
window” on page 35.
2. Disable the switch, as described in “Enabling and disabling a switch” on page 40.
3. Select the Switch tab.
4. Enter a new domain ID in the Domain ID field.
The domain ID range depends on the switch interop mode:
• For IM0, the range is between 1 and 239.
• For IM2, it depends on the selected offset value.
• For IM3, it depends on the selected offset value.
5. Click Apply.
6. Enable the switch, as described in “Enabling and disabling a switch” on page 40.
Viewing and printing a switch report
The switch report includes the following information:
• A list of switches in the fabric
• Switch configuration parameters
• A list of ISLs and ports
• Name Server information
• Zoning information
• SFP serial ID information
Perform the following steps to view or print a report.