Dell W5300 Workgroup Laser Printer - Manual (Page 142)

Setup Menu.
Install additional printer
memory.
See also: Setup Menu
4<x>
Unsupported
Firmware Card
The printer detects an
unsupported version of firmware
on the installed firmware card
during the power-on cycle. Turn the printer off, and then press
and hold Go while turning it on. The
printer reads the code on the system
card and bypasses the code on the
firmware card.
Remove the firmware card.
54 Network <x>
Software Error
The printer cannot establish
communications with an installed
network port. Press Go to clear the message and
continue printing. The job may not
print correctly.
Program new firmware for the
network interface by way of the
parallel port.
Press Menu to open the Job Menu
and reset the printer.
54 Std Network
Software Error
55 Unsupported
Flash
in Slot X
The printer detects an
unsupported flash memory card in
one of the connectors. Turn the printer off. Remove the
unsupported option card.
55 Unsupported
Option in Slot X
The printer detects an
unsupported option card in one of
the connectors. Turn the printer off. Remove the
unsupported option card.
56 USB Port <x>
Disabled
Data has been sent to the printer
through a USB port, but the USB
port is disabled. Press Go to clear the message. The
printer discards any data received
through the USB port.
Make sure the USB Buffer menu item
in the USB Menu is not set to
Disabled.
See also: USB Buffer
56 Standard USB
Port Disabled
58 Too Many
Trays Attached
Too many drawers with matching
trays are installed on the printer. Turn off and unplug the printer. Remove
the additional drawers. Plug in the printer
and turn it on.
You have installed an Remove the device and press Go to clear