Installing the optical drive tray, E figure 3-17 – Dell POWEREDGE 1950 User Manual
Page 74
74
Installing System Components
Figure 3-17.
Removing and Installing the Optical Drive Tray
Installing the Optical Drive Tray
1
Align the optical drive tray with its opening in the front panel.
The optical drive opening is located directly below the SAS daughter card bay.
2
Slide in the drive tray until the tray snaps into place. See Figure 3-17.
3
Connect the optical-drive cable from the back of the drive. See Figure 3-17.
4
Replace the SAS controller daughter card.See "Installing a SAS Controller Daughter Card or SAS RAID
Controller Daughter Card" on page 56.
5
Close the system. See "Opening and Closing the System" on page 46.
6
Replace the bezel. See "Removing and Replacing the Front Bezel" on page 45.
7
Reconnect your system and peripherals to their electrical outlets, and turn on the system.
1
optical -drive tray
2
optical-drive cable
3
optical-drive release tab
4
optical drive
3
2
1
4