Dell PowerEdge RAID Controller S110 - Manual (Page 24)

22 Installing the Drivers
Installing bccfg3.sys Drivers
Follow the procedure below to install the bccfg3.sys driver:
1 After you install the operating system on the Dell PowerEdge systems with
the S110 card, navigate to the Computer Management window.
2 Select the Other Devices, right click on RAIDCORE Configuration SCSI
Processor Device.
A list of options are displayed.
3 Click Update Driver Software.
The Update Driver Software - RAIDCORE Configuration SCSI
Processor Device window is displayed.
4 Select the Browse my computer for driver software tab.
5 Select the folder that contains drivers for your hardware and click OK.
6 Click Next.
NOTE: If your system supports OpenManage v7.4 and later, the bccfg.sys driver is
installed automatically.
Performing the PERC S110 Adapter Management Setup Procedure
The PERC S110 management setup procedure is described in Dell
OpenManage Server Administrator Storage Management. To set up a PERC
S110 on your system, see the Storage Management procedures located at the
Dell Support website at dell.com/support/manuals.
A5_bk0.book Page 22 Thursday, May 29, 2014 11:37 AM