Dell OptiPlex GX280 - Manual (Page 258)

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
Removing a CD/DVD Drive
1. Follow the procedures in " Before You Begin ."
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the
cable connectors.
2. Pull up on the drive release latch and slide the drive towards the back of the computer. Then, lift up to remove the
drive from the computer.
1 drive release latch
2 CD/DVD drive
3. Disconnect the power and CD/DVD drive cables from the back of the drive.
Installing a CD/DVD Drive
1. Unpack the drive and prepare it for installation.
Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are
installing an IDE drive, configure the drive for the cable select setting.
2. If you are installing a new drive:
a. Press the two snaps on the top of the panel insert and rotate the insert toward the front of the computer.
b. Remove the shoulder screws (3) from the panel insert.
3. If you are replacing an existing drive: