Dell OptiPlex GX280 - Manual (Page 299)

1 power cable
2 floppy-drive cable
3 floppy-drive connector (DSKT)
3. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive
bay.
Installing a Floppy Drive
1. If you are replacing a drive and the new drive does not have the bracket rails attached, remove the rails from the old
drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the
screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two
screws on each rail).