Cable routing – Dell OptiPlex GX280 User Manual
Page 304
6. If you are installing a new CD/DVD drive rather than replacing a drive,
remove the front- panel inserts
.
7. If you are installing a drive that has its own controller card, install the controller card in a card slot.
8. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
9. Close the computer cover.
NOTICE:
To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the
computer.
10. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
11. After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following
message to appear on the screen at the next computer start-up:
ALERT! Cover was previously removed.
12.
Reset the chassis intrusion detector
by changing Chassis Intrusion to On or On-Silent.
NOTE:
If an admin password has been assigned by someone else, contact your network administrator for information
on resetting the chassis intrusion detector.
13. Update your configuration information by setting the appropriate Drive option (0 or 1) under Drives. See "
" for more information.
14. Verify that your computer works correctly by running the
Cable Routing