Processor, Removing the processor – Dell OptiPlex GX280 User Manual
Page 275
Processor
Dell™ OptiPlex™ GX280 Systems User's Guide
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from
your body before you touch any of your computer's electronic components. You can do so by touching an
unpainted metal surface on the computer chassis.
Removing the Processor
1. Follow the procedures in "
2. Loosen the captive screw on each side of the heat sink shroud assembly.
CAUTION:
Despite having a plastic shield, the heat sink assembly may be very hot during normal
operation. Be sure that it has had sufficient time to cool before you touch it.
3. Rotate the heat sink shroud assembly upward, and remove the assembly from the computer.
1 heat sink shroud assembly
2 captive screw housing (2)
NOTICE:
If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not installing
a processor upgrade kit from Dell, reuse the original heat sink when you install your new processor.
4. Open the processor cover by sliding the release lever from under the center cover latch on the socket. Then, pull the
lever back to release the processor.