Removing an expansion card, 2 open the system. see "opening the system, 4 remove the expansion card – Dell POWEREDGE R710 User Manual

Page 122: 6 close the system. see "closing the system, D riser 1. see "removing an, Expansion card

Advertising
background image

122

Installing System Components

Removing an Expansion Card

CAUTION:

Many repairs may only be done by a certified service technician. You

should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.

1 Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet.

2 Open the system. See "Opening the System."
3 Disconnect any cables connected to the expansion card.
4 Remove the expansion card:

a

Open the expansion-card latch at the back of the system chassis. See
Figure 3-26.

b

Grasp the expansion card by its top corners, and carefully pull the card
from the expansion-card connector.

5 If you are removing the card permanently, install a metal filler bracket over

the empty expansion slot opening and close the expansion-card latch.

NOTE:

You must install a filler bracket over an empty expansion slot to

maintain Federal Communications Commission (FCC) certification of the
system. The brackets also aid in proper cooling and airflow inside the system.

6 Close the system. See "Closing the System."
7 Reconnect your system and peripherals to their electrical outlets, and turn

on the system.

Advertising