Dell PowerEdge C5230 - Manual (Page 55)

Using the System Setup Program 55
Serial Port Mode 115200 8-n-1*
57600 8-n-1
38400 8-n-1
19200 8-n-1
9600 8-n-1 Selects serial port
transmission speed. The
speed must be matched on
the other side. Long or
noisy lines may require
lower speeds.
Flow Control None*
Hardware Flow control can prevent
data loss from buffer
overflow. When sending
data, if the receiving
buffers are full, a 'stop'
signal can be sent to stop
the data flow. Once the
buffers are empty, a 'start'
signal can be sent to re-
start the flow. Hardware
flow control uses two wires
to send start/stop signals.
Redirection After BIOS
POST
Disabled
Always* Redirection After BIOS
POST
Terminal Type ANSI*
VT100
VT-UTF8 Emulation: ANSI:
Extended ASCII char set.
VT100: ASCII char set.
VT-UTF8: Uses UTF8
encoding to map Unicode
chars onto 1 or more bytes.
VT-UTF8 Combo Key
Support
Disabled
Enabled* Enable VT-UTF8
combination key support
for ANSI/VT100 terminals.
NOTE: BIOS setup screens display at 100 (columns) x 31 (lines). Change the client-side
console utility settings to support 100 (columns) x 31 (lines) for accurate screen display.
Menu Fields Settings Comments