Restrictions for multihop, Required configuration tasks for multihop, Enabling vpdn and multihop functionality – Cisco 10000 User Manual

Page 261

Advertising
background image

9-3

Cisco 10000 Series Router Software Configuration Guide

OL-2226-23

Chapter 9 Configuring Multihop

Restrictions for Multihop

Restrictions for Multihop

The Multihop feature has the following restrictions:

•

The performance routing engine, part number ESR-PRE1 does not support the Multihop feature.

•

Tunnel switching is based on a session’s domain or tunnel in which the session arrived. The
Cisco 10000 router does not support switching of individual sessions by using the CLI.

•

The Cisco 10000 router does not support multichassis Multilink PPP (MLPPP).

•

The Cisco 10000 router supports the Multihop feature for L2TP, but does not support the L2F
protocol.

•

You cannot apply per session features to switched sessions. For example, you cannot apply an ACL
or a service policy to the sessions.

To preserve the IP TOS field of tunneled IP packets, the following restrictions apply:

•

The Cisco 10000 router supports only the L2TP tunneling protocol.

•

The tunneled link must carry IP to preserve the TOS field.

•

The Cisco 10000 router does not support proxy PPP dialin.

Required Configuration Tasks for Multihop

To configure the Multihop feature on the Cisco 10000 router, perform the following configuration tasks:

•

Enabling VPDN and Multihop Functionality, page 9-3

•

Terminating the Tunnel from the LAC, page 9-4

•

Mapping the Ingress Tunnel Name to an LNS, page 9-4

Enabling VPDN and Multihop Functionality

To enable VPDN and multihop functionality, enter the following commands in global configuration
mode:

Command

Purpose

Step 1

Router(config)# vpdn enable

Enables VPDN functionality.

Step 2

Router(config)# vpdn multihop

Enables VPDN multihop functionality.

Advertising