Control panel, Control panel -7, Figure 4-5 – Dell OptiPlex NX1 User Manual
Page 77: Control panel removal -7, Rqwuro3dqho
Advertising
Removing and Replacing Parts on the Low-Profile Chassis
4-7
&RQWURO3DQHO
)LJXUH &RQWURO 3DQHO 5HPRYDO
To remove the control panel, follow these steps:
1.
Disconnect the control panel cable from the PANEL connector on the sys-
tem board (see Figure 4-15).
2. From the inside of the chassis, remove the mounting screw holding the
control panel to the chassis.
3. Remove the control panel from the chassis.
When you reinstall the control panel, be sure to put the right side of the control
panel behind the mounting tab.
control panel cable
control panel
mounting screw
mounting tab
chassis
Advertising