Dell OptiPlex NX1 - Manual (Page 79)

Removing and Replacing Parts on the Low-Profile Chassis 4-9
,QFK'LVNHWWH'ULYH$VVHPEO\
)LJXUH  ,QFK 'LVNHWWH 'ULYH 5HPRYDO
To remove the 3.5-inch diskette drive assembly, follow these steps:
1. Disconnect the DC power cable and the interface cable from the back of
the diskette drive.
2. Press the two 3.5-inch diskette-drive-assembly latches to the left to release
the assembly.
Rotate the left side of the assembly up, and lift the assembly out of the
chassis.
3. Remove the two drive-mounting screws from the left side of the drive, and
remove the drive from the bracket.
When you replace the 3.5-inch diskette drive, be sure that the mounting holes
on the right side of the drive engage the two hooks on the bracket.
3.5-inch diskette-drive-assembly
latches (2)
drive-mounting
screws (2)
hooks (2)
front of computer