Two Brothers Racing Honda CBR1000RR User Manual

Cbr1000rr, Honda

Advertising
background image

6. Install the muffler bracket using the supplied bracket and

OEM nut and bolt.

7. Loosely attach the V.A.L.E.

TM

muffler to the stainless

steel V.A.L.E.

TM

connector tube using the supplied

6x20mm socket head cap screws and 6mm split
washers.

8. Slide rubber-lined muffler clamp over TBR exhaust

canister, loosely slide the barrel clamp over the slip-tube.
Install the muffler assembly to the bike by attaching the
muffler clamp to the custom bracket using the supplied
counter-sunk washer, bolt and nut.

9. Once the muffler is aligned tighten the 4 6x20mm

V.A.L.E.

TM

screws with the supplied ball end hex key

Tighten the barrel clamp. Attach o2 sensor. Re-install
OEM lower fairing bolt to left side.

10. Install TBR lower side cover to slip-tube tabs and rear

right side fairing mount using supplied bolts.

11. Make sure everything is aligned and tighten all

hardware.

12. Before you run the bike, clean off all fingerprints and

dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Run
the bike and enjoy. Check for gaps or leaks. After 50 to
100 miles, recheck all fasteners for tightness.

Parts List

Installation Instructions

1. Make sure the bike is completely cool before starting

the installation. Make sure the bike is secure on a
centerstand or ideally a service lift.

2. Locate servo-motor cover under right side tail section in

wheel well. Remove push-pins to access.

3. Mark the location of servo. Disconnect Servo Butterfly

valve cable and re-route cable as shown (It will be
removed later with exhaust). Return servo to its original
location or engine light may be tripped.

4. Remove the lower fairing bolt from left side of

motorcycle to access o2 sensor and remove sensor.

5. Remove OEM muffler assembly.

Honda

CBR1000RR

V.A.L.E.™ Slip-on Exhaust System with M-2 Canister
Part # 005-31904

Qty.

Description

Part Number

1

M-2 Muffler Canister

Varies

1

Slip-On Tube Assembly

005-31904S

1

HARDWARE KIT

005-319-3

1

Custom Mounting Bracket

005-206B

1

Lower side cover

005-319SC

1

X-Ring Kit

005-7-2-3KIT

1

Muffler Clamp

005-2C

1

Barrel Clamp

005-27-63MSH

2

Button Head Cap Screws 6x10mm

005-BH608

1

8x20mm Socket Head Cap Screw

005-SHF820

1

8mm Aluminum Washer

005-WA8

1

8mm Flange Nut

005-FN8

1

O2 Sensor Kit

005-92-22KIT

1

TBR Sticker Kit

015-10212

Advertising