V.a.l.e, Zx-6r, 2009 kawasaki – Two Brothers Racing Kawasaki ZX-6R User Manual
Page 2
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
Install the TBR muffler assembly and attach using the
flange bolt and nut to secure the muffler in place.
Check alignment and tighten muffler and the 4 6x14mm
V.A.L.E.™ socket head cap screws.
Tighten OEM joint clamp.
Install TBR fender eliminator kit using the original bolts
and supplied nuts, the nuts will be inside the bike under
seat.
Attach turn signals and plate light bolts using the wire
splice connectors supplied to the correct wires in the
harness as shown in the Wiring Diagram.
Re-install seats and covers.
Double check all your work.
Before you run the bike, clean off all fingerprints and
dirt, as any oily residue will etch the metal and become
somewhat permanent when the system gets hot. Also,
remove any plastic film from the name badge(s) and or
canister clamp(s). Run the bike and enjoy. It is normal
for some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from inside
the pipe burning off. Check for gaps or leaks. If you find a
leak, a little high temperature silicon sealant should fix it.
After 50 to 100 miles, recheck all fasteners for tightness.
12.
13.
14.
15.
16.
17.
18.
19.
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
WIRING DIAGRAM
Lef
t Tu
rn
Sig
nal
(Gr
ey
con
nec
tor
)
R
ed
Plate Lights
Righ
t Turn
Sign
al
(Blac
k con
necto
r)
Wiring Harness
Blac
k/Y
ellow
Red
Blac
k
Blac
k
Red
2009 Kawasaki
ZX-6R
V.A.L.E.™ Slip-on Exhaust System with M-2 Canister
Part # 005-2410406V, 005-2410407V, 005-2410408V