Two Brothers Racing Suzuki DL650V-Strom - Manual

1. Make sure the bike is completely cool before
starting the installation. Make sure the bike is
secure on a centerstand or ideally a service lift.
2. Remove lower exhaust mounting bolt.
3. Remove front header pipe.
4. Remove rear pipe assemblyt.
5. Install TBR mid-pipe using OEM mounting
hardware and supplied 57mm barrel clamps.
6. Re-install OEM front header pipe.
7. Attach muffler to TBR slip system using the
supplied X-ring, 6x20mm socket head cap screws
and lock washers that are provided, leave loose for
now. Slide rubber lined muffler clamp with supplied
bolt and spacer. Slide barrel clamp on end of tube.
8. Loosely attach muffler to bike using the OEM
hardware on slip-tube mount and install muffler
clamp using the supplied bolt and spacer.
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Installation Instructions
Warranty Information
Two Brothers Racing products are intended for closed course competition purposes only, and therefore
are sold “as is” without warranty. Two Brothers Racing specifically disclaims any warranties of
merchantability or fitness for a particular purpose and disclaims all responsibility for consequential and
incidental damages or any other losses arising from the use of these products or parts. Not tested for use
Suzuki
DL650 V-STROM
V.A.L.E.™ Full Exhaust System with M-2 Exhaust Canister
Part # 005-3140106V, 005-3140107V, 005-3140108V