Two Brothers Racing 2011 Suzuki GSX-R600 / 750 - Manual

1. Make sure the bike is completely cool before
starting the installation. Make sure the bike is
secure on a centerstand or ideally a service lift.
2. Remove OEM muffler heatshield.
3. Remove OEM muffler assembly.
4. Attach muffler to TBR slip system using the supplied
X-ring, 6x20mm socket head cap screws and lock
washers that are provided, leave loose for now.
Slide rubber lined muffler clamp and barrel clamp
on and install to bike.
5. Loosely attach muffler to bike using the OEM bolt
and nut and install muffler clamp to inside of
passenger footpeg.
6. Check for clearance and alignment, then tighten all
the bolts in this order: X-ring bolts, muffler mount,
and finally barrel clamp.
7. Before you run the bike, clean off all fingerprints
and dirt, as any oily residue will etch the metal and
become somewhat permanent when the system
gets hot. Run the bike and enjoy. It is normal for
some white smoke to appear the first time you start
the bike. This is packing/manufacturing oil from
inside the pipe burning off. Check for gaps or leaks.
If you find a leak, a little high temperature silicon
sealant should fix it. After 50 to 100 miles, recheck
all fasteners for tightness.
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Parts List
IMPORTANT - PLEASE READ CAREFULLY
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Also,
make sure the bike is secure on a centerstand or ideally a service lift during
installation. Be sure to save all stock components for possible use later.
Installation Instructions
Qty. Description Part Number
1 M-2 Muffler Canister Varies
1 Canister Clamp with Rubber Liner Varies
1 Header Kit 005-30404S
1 HARDWARE KIT 005-304-3
2 X-Ring (half) 005-7-2-2
1 66mm Barrel Clamp 005-27-61MSH
4 6x20mm Socket Head Cap Screws 005-SH620
4 6mm Split Lock Washer 005-WL6
1 T20 Torx Hex Key 005-9-15820
1 5mm Ball End Hex Key 005-9-18610
1 TBR Sticker Kit 015-10212
2011 Suzuki
GSX-R600 / 750
V.A.L.E.™ Slip-on Exhaust System with M-2 Exhaust Canister
Part # 005-3040406V, 005-3040407V, 005-3040408V
Warranty Information
two brothers racing products are intended for closed course competition purposes only, and therefore are
sold “as is” without warranty. two brothers racing specifically disclaims any warranties of merchantability
or fitness for a particular purpose and disclaims all responsibility for consequential and incidental damages
or any other losses arising from the use of these products or parts. not tested for use with oeM or
aftermarket accessories.