Two Brothers Racing Suzuki V-Strom 1000 User Manual
V-strom 1000, Suzuki
Installation Instructions
1.
Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a center stand
or ideally a service lift.
2.
Remove OEM right side saddlebag if equipped.
3.
Remove OEM exhaust by removing mounting bolt and
loosening muffler joint clamp. Keep OEM washer and nut
for use with TBR system.
4.
Apply a thin layer of anti-seize to muffler inlet. Attach
S1R muffler to slip tube using supplied hook springs.
Suzuki
V-Strom 1000
Slip-on Exhaust System
Part# 005-4130405-S1
IMPORTANT - PLEASE READ CAREFULLY
Warranty
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
Two Brothers Racing products are intended for closed course competition
purposes only.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions first
before starting installation. Make sure the motorcycle and exhaust system are
completely cool before starting the installation. Also, make sure the bike is secure
on a center stand or ideally a service lift during installation. Be sure to save all
stock components for possible use later.
**This product has not been tested with all available accessories and some items
may cause excessive heat. Excessive heat may cause damage to your vehicle. Two
Brothers Racing will not be responsible for damaged parts.
5.
Slide barrel clamp over TBR slip tube and install onto
OEM mid-pipe. OEM gasket will not be re-used.
6.
Slide rubber lined muffler clamp over S1R muffler and
attach to mount using supplied 8x60mm bolt and 18mm
spacer. Then use OEM washer and nut.
7.
Make sure muffler is properly aligned. Then tighten
muffler mount bolt and slip-tube barrel clamp.
8.
If equipped, re-install OEM saddlebag.