Two Brothers Racing Yamaha Bolt - Manual (Page 2)

Care & Cleaning / Warranty
Keep system free of dirt and moisture. Store in a cool, dry place. For
cleaning use a mild spray cleaner. Always apply cleaner or polish with a
soft, clean cloth.
Stainless Header System: Polished stainless steel pipes will turn a light
golden hue after a few heat cycles, this is a normal characteristic of high
quality stainless steel.
Carbon Fiber Mufflers: Always make sure the fiberglass packing inside
is in good condition and not burned out, as exhaust heat inside an empty
canister will deteriorate the Carbon Fiber sleeve. TBR sells repack kits (TBR
part # 005-10038) that include new rivets and repack material as well as a
drill bit (#30), making it easy to do yourself. Also, NEVER dyno test your bike
with carbon fiber mufflers installed - the intense heat and lack of cooling air
can quickly cause the CF material to burn. Two Brothers Racing does not
provide a warranty for burned carbon fiber.
Aluminum Mufflers: Use an aluminum or mag wheel polish such as
Mother’s to restore the bright finish to factory spec.
Two Brothers Racing products are intended for closed course competition
purposes only, and therefore are sold “as is” without warranty. Two Brothers
Racing specifically disclaims any warranties of merchantability or fitness for
a particular purpose and disclaims all responsibility for consequential and
incidental damages or any other losses arising from the use of these products
or parts.
Installation Instructions
11. Attach muffler to mounting bracket using supplied 5/16” x 3/4” bolts.
12. Apply anti-seize to threads of O2 sensor and install into TBR system.
Tighten to snug.
13. Install OEM heat shields onto headers with OEM hardware. Install TBR
heat shield onto connector pipe using supplied 6x8mm button head
bolts.
14. Double check all your work and tighten all hardware.
15. Before you run the bike, clean off all fingerprints and dirt, as any oily
residue will etch the metal and become somewhat permanent when the
system gets hot. Also, remove any plastic film from the name badges.
Run the bike and enjoy. It is normal for some white smoke to appear
the first time you start the bike. This is packing/manufacturing oil from
inside the pope burning off. Check for gaps or leaks. If you find a leak, a
little high temperature silicon sealant should fix it. After 50 to 100 miles,
recheck all fasteners for tightness.
Qty. Description Part Number
1 Muffler Canister 005-369-M
1 Header 005-36901H
2 Header Flange 005-369-15
1 Heat Shield 005-369-HS
2 45mm Hook Spring 005-S45
2 Flange Bolt 5/16”-18x3/4” 005-FB51634
2 Hex Head Flange M10-1.25x25 005-FB1025B
2 Button Head Cap Screw 005-BH608
2 Clip Nut 5/16” 005-10-516CN
1 Spring Puller 005-SP
1 Bracket 005-369-B2
1 Thread Locker 031-P09178
Yamaha
BOLT
Part # 005-3690199