Two Brothers Racing Yamaha Grizzly 700 - Manual

V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Installation Instructions
2007 Yamaha
GRIZZLY 700
V.A.L.E.™ Slip-On Exhaust System with M-7 Aluminum Canister
Part # 005-1790406V
1. Make sure the quad is completely cool before starting
the installation. Make sure the quad is secure on a level
surface and the wheels are chocked to prevent the quad
from rolling.
2. For easier installation, remove the body parts listed:
- Seat - Left foot pan assembly
- Left side body panel
3. Remove the mid-pipe joint cover to expose the springs
connecting the head pipe with the mid-pipe. Remove
the spring. The OEM gasket will be re-used with the TBR
exhaust system.
4. Remove the muffler mount bolt and remove the muffler
assembly.
5. Remove the OEM heat shield from the muffler assembly
and attach it to the bracket located on the TBR muffler
using the original hardware (We applied a small amount
of grease onto each bolt to help it stick in place while we
aligned the heat shield to the TBR brackets).
6. Use the 4 (four) 6 x 14mm socket head cap screws and
split lock washers to loosely attach the X-Lite™ ring to
muffler inlet using the split-lock washers provided. (See
V.A.L.E.™ Assembly Detail below) Leave loose for now.
7. Make sure gasket is either in the TBR slip-on tube or
on the OEM headpipe and slip the muffler assembly
into place (joining the TBR slip-on and OEM headpipe).
Attach the muffler with the 8 x 25mm Flange Bolt
provided.
8. Attach spring at muffler joint.
... Continued on Page 2
Muffler Inlet
X-Lite™ Ring
Slip Tube
V.A.L.E.™ Assembly Detail
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”
without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular
purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use
of these products or parts.
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install this
performance part, please consult with your local motorcycle dealer. Read all
instructions first before starting installation. Make sure the motorcycle and
exhaust system are completely cool before starting the installation. Be sure
to save all stock components for possible use later.
**This product has not been tested with all available accessories and some
items may cause excessive heat. Excessive heat may cause damage to your
vehicle. Two Brothers Racing will not be responsible for damaged parts.