Two Brothers Racing Yamaha R6 User Manual

Yamaha r6

Advertising
background image

IMPORTANT - PLEASE READ CAREFULLY

Two Brothers Racing products are intended for closed course competition purposes

only.

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions first

before starting installation. Make sure the motorcycle and exhaust system are

completely cool before starting the installation. Also, make sure the bike is secure

on a centerstand or ideally a service lift during installation. Be sure to save all stock

components for possible use later.

Installation Instructions

Yamaha R6

Complete Exhaust System
Part # 005-4060105-S1

1.

Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a rear stand or
ideally a service lift.

2.

Remove lower right fairing from the motorcycle.

3.

Remove muffler inlet cover from front of muffler to expose
exhaust valve cables (noise reduction valve).

4.

Remove cables from muffler and cable clamp from right
side rear set assembly.

5.

Remove muffler joint clamp and muffler mounting bolt.

6.

Remove muffler assembly.

7.

Remove bracket holding the brake reservoir to the frame.

8.

Remove the noise reduction valve servo bracket from the
frame.

9.

Remove servo by pulling out from the right side of the
motorcycle and disconnect the cables. Disregard cables.

10. Remount the servo without the cables. Make sure servo is

plugged into wiring harness. This step is necessary in order to
keep an error code from being displayed on the LCD screen.

11. Reinstall the brake reservoir.

12. Remove the stock header exhaust port nuts (8 nuts total) in

order to remove the stock headers.

13. Allow the head pipe assembly to swivel downward.

Care & Cleaning / Warranty

Care & Cleaning
Keep system free of dirt and moisture. Store in a cool, dry place. For cleaning use a mild spray cleaner.

Always apply cleaner or polish with a soft, clean cloth.
Stainless Header System: Polished stainless steel pipes will turn a light golden hue after a few heat

cycles, this is a normal characteristic of high quality stainless steel.
Carbon Fiber Mufflers: Always make sure the fiberglass packing inside is in good condition and not
burned out, as exhaust heat inside an empty canister will deteriorate the Carbon Fiber sleeve. TBR sells
repack kits (TBR part # 005-10038) that include new rivets and repack material as well as a drill bit (#30),
making it easy to do yourself. Also, NEVER dyno test your bike with carbon fiber mufflers installed - the
intense heat and lack of cooling air can quickly cause the CF material to burn. Two Brothers Racing does
not provide a warranty for burned carbon fiber.

Aluminum Mufflers: Use an aluminum or mag wheel polish such as Mother’s to restore the bright finish to
factory spec.

Warranty Information
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold “as

is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness for

a particular purpose and disclaims all responsibility for consequential and incidental damages or any other losses

arising from the use of these products or parts.

Advertising