Two Brothers Racing Yamaha R1 FE User Manual

V.a.l.e, 2009 yamaha, Wiring diagram lef t tu rn sig nal

Advertising
background image

IMPORTANT - PLEASE READ CAREFULLY

We recommend that this performance part be installed by a qualified motorcycle

technician. If you have any doubts as to your ability to install this performance

part, please consult with your local motorcycle dealer. Read all instructions first

before starting installation. Make sure the motorcycle and exhaust system are

completely cool before starting the installation. Also, make sure the bike is secure

on a centerstand or ideally a service lift during installation. Be sure to save all stock

components for possible use later.

Installation Instructions

1. Remove passenger seat.

2. Locate fender wires and un-plug from main harness.

3. Remove the 3 bolts securing the OEM fender to

motorcycle.

4. Remove fender assembly.

5. Cut OEM wires on fender assembly back 6” (inches) from

plugs.

6. Attach gray plug to left side turn signal using the supplied

buttsplace connector.

7. Attach black plug to right side.

8. Attach the 2 bullet connectors to the plate light bolts.

Black goes to black.

Red goes to blue/red.

9. Attach turn signals and plate lights to TBR fender and

attach using the OEM bolts and supplied 6mm flange nuts

to motorcycle.

10. Route wires through center hole and plug into main

harness.

11. Use zip-tie tabs and zip-ties to keep wires away from

exhaust.

12. Double check all your work.

13. Re-install passenger seat.

14. Before you run the bike, clean off all fingerprints and

dirt, as any oily residue will etch the metal and become

somewhat permanent when the system gets hot. Also,

remove any plastic film from the name badge(s) and or

canister clamp(s). Run the bike and enjoy. It is normal

for some white smoke to appear the first time you start

the bike. This is packing/manufacturing oil from inside

the pipe burning off. Check for gaps or leaks. If you find a

leak, a little high temperature silicon sealant should fix it.

After 50 to 100 miles, recheck all fasteners for tightness.

Qty.

Description

Part Number

1

Fender Bracket

005-23804B

2

Lighted License Plate Bolt

005-8504LTZ

1

Turn Signals (set of 2)

005-88T2

6

Butt Splice Connectors

005-BS1614

2

Zip Tie

005-ZT458B

2

Zip Tie Tab

005-ZTM4

3

6mm Flange Nut

005-FN6

1

TBR Sticker Kit

015-10212

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

2009 Yamaha

R1

Fender Eliminator Kit
Part # 013-238

Parts List

WIRING DIAGRAM

Lef

t Tu

rn

Sig

nal

(Gr

ey

con

nec

tor

)

Blue/R

ed

Plate Lights

Righ

t Turn

Sign

al

(Blac

k con

necto

r)

Wiring Harness

Blac

k

Red

Blac

k

Blac

k

Red

Warranty

two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”

without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular

purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the

use of these products or parts.

Advertising