Two Brothers Racing Can-Am Spyder Spyder RS - Manual (Page 5)

ITBR001-283-A.02 www.twobros.com 2011-2014 CanAm Spyder RT - 5
Posi tap
TPS
FIG
.G
FIG
.H
FIG
.J
12. Plug the YELLOW colored wires from the Juicebox Pro in-line of the stock wiring
harness and injector.
13. Unplug the stock wiring harness from the injector on the right hand side as
shown in Figure H.
This connection is located to the right, rear of the air box.
14. Plug the ORANGE colored wires of the Juicebox Pro in-line of the stock wiring
harness and injector.
15. Locate the Throttle Position Sensor (TPS) on the left
side of the throttle bodies.
16. Using the supplied posi-tap, attach the GREY wire
of the Juicebox Pro to the WHT/BRN wire of the TPS
wiring harness.
Figure J is shown with the TPS harness disconnected
from the sensor. Make sure to reconnect the harness
to the sensor.