Two Brothers Racing Can-Am Spyder Spyder RS - Manual (Page 6)

ITBR001-283-A.02 www.twobros.com 2011-2014 CanAm Spyder RT - 6
17. Attach the ground wire of the Juicebox Pro to the rear cylinder head on the left
side as shown in Figure K.
Remove the stock bolt and insert the bolt through the eyelet of the Juicebox Pro
ground wire and reinstall the bolt into head.
18. Unplug the stock wiring harness from the front O2 sensor as shown in Figure L.
This connection is located on the left hand frame rail by the front cylinder.
19. Plug the 4-pin connector labeled FRONT in-line of the stock O2 sensor and wiring
harness.
FIG
.K
FIG
.L
FIG
.M
20. Unplug the stock wiring harness from the rear O2 sensor as shown in Figure M.
This connection is located on the right side of the vehicle to the right of the air
box.