Two Brothers Racing Honda TRX700XX User Manual
Page 3
Advertising
ITBR001-201
2008-10 Honda TRX700XX - 3
Fi
gu
re
A
Fi
gur
e B
Fi
gu
re
C
remove
unplug
unplug
The ignition must be turned OFF before installation.
1
Remove the seat.
2
Remove the rubber cover and the plastic cover over the battery and throttle body as
shown in Figure A.
3
Unplug the grey 2-pin stock wiring harness connector from the injector as shown in
Figure B.
This connector is located on top of the throttle body.
4
Unplug the black 5-pin stock wiring harness from the throttle position sensor (TPS)
as shown in Figure C.
The TPS connector is located on the lower left side of the throttle body.
Advertising