Two Brothers Racing Suzuki Bandit 1250 - Manual (Page 4)

ITBR001-183 www.twobros.com 2009-2010 Suzuki Bandit 1250 - 4
Figure D
Figure E
7. Locate the Throttle Position Sensor (TPS).
The TPS is located on the left hand side of the throttle
bodies.
8. Unplug the TPS connector to gain access to the wires.
9. Attach the supplied posi-tap to the PINK wire with a
BLACK stripe as shown in Figure D.
This connection can be done further up the harness
than what is shown in Figure D for a cleaner install.
10. Attach the GREY wire from the Juice Box Pro to the
posi-tap.
11. Attach the TPS connector back onto the throttle body.
12. Attach the ground wire from the Juice Box Pro to the negative side of the battery
as shown in Figure E.
13. Reinstall the fuel tank.
Verify the Juice Box Pro harness does not get pinched.
14. Using the supplied velcro, secure the Juice Box Pro in the tail section of the trunk.
Make sure to clean both surfaces with the alcohol swab before attaching.
15. Locate the stock O2 sensor.
The stock O2 sensor is located under the left hand side cover.
16. Unplug the sensor from the stock wiring harness.
17. Attach the O2 optimizer to the main wiring harness.
The stock O2 sensor will not be connected to anything anymore.
ground wire
18. Reinstall the seat.