Two Brothers Racing Triumph Street Triple - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2009 Triumph Street Triple Installation & Operation Manual
Part # 008-248
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-248 (#913005)
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
NOTE: Re check your wire routing and JUICE BOX™ location
and make certain that in no way the wires can come into
contact with any moving parts or high heat source and that
the JUICE BOX™ is mounted in a way as to not cause a
handling problem with the machine.
Re-install fuel tank and seat assembly.
Start the bike. The green LED should scroll for about 3-5
seconds and then go to 1 or more steady green LED’s or
a single slow flashing green LED. If the number 1 green
and number 8 red LED continue flashing after startup,
an injector wiring error is indicated. Re-check the wires
from the JUICE BOX™ and make sure they are connected
to the proper wires of your bike’s stock harness. MAKE
SURE you have the correct connectors selected in the
stock harness. DO NOT PROCEED UNLESS ABOVE
CONDITIONS ARE MET.
8.
9.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance
part, please consult with your local motorcycle dealer. Read all instructions
first before starting installation. Make sure the vehicle and exhaust system are
completely cool before starting the installation. Also, make sure the vehicle is
secure during installation. Be sure to save all stock components for possible use
later.
The Juice Box™ is legal ONLY for closed course race vehicles. The Juice Box™ is
not applicable, nor inteded for use on EMISSIONS CONTROLLED street, highway
or off-road vehicles. The Juice Box™ is not applicable, nor inteded for use on
aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove the seat assembly.
Remove the fuel tank. (Fig. 1 & 2)
Locate the injector and O2 sensor plugs. Unplug one
at a time and plug the male/female ends into the JUICE
BOX™ plugs as shown for all the injectors and the O2
sensor.
Attach the ground. (Fig. 3)
Run JUICE BOX™ wires to rear of motorcycle and secure
in the storage compartment behind battery.
Make sure all wires are secured.
1.
2.
3.
4.
5.
6.
7.
Continued on page 2
Fig 1
Fig 2
Fig 3