Two Brothers Racing Kawasaki Brute Force - Manual (Page 2)

5) COIL MOUNTING, (see pictures)
Place brackets on coils as shown. Bolts should sandwich coil between brackets and flat washers. Tighten
locknuts last, but not all the way. Position coil on frame, using one mounting tab, and one zip-tie. (see pictures)
Tighten securely once coil is in position. Route the sparkplug wires in the stock location, and plug the sparkplug
boots back onto the sparkplugs. Unwind electrical tape and cut back sleeve to relieve strain on coil primary
wires at ATV harness. Connect the Black/Yellow wire to Orange wire on Dyna coil terminal with the red dot.
Connect the Blue/White (Rear) or Green/White (Front) wire to the other Dyna coil terminal (not the red dot).
Check the wiring. Make sure connections are tight and secure. Replace body parts, panels, and connect battery.
Turn ignition key on. Start the engine. Installation is complete!
1. Front cylinder coil location: 2. Dyna coil for front cylinder,
Front left wheel well. mounted to frame.
3. Rear cylinder coil location: 4. Dyna coil for rear cylinder,
Right side above floor board. mounted to frame.
DYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com 2801343B