Two Brothers Racing Kawasaki KFX700/V-Force Dyna FS Ignition - Manual

Dyna FS Ignition
DFS 2-14 2003-2004 Kawasaki KFX700 V-Force
CAUTION! 9,700 RPM LIMIT (8,700 stock)
Congratulations on your purchase of a Dynatek ignition. Please take a moment to read these instructions completely before
installing the ignition. The installation will only take a few minutes, but proper setup for your specific bike will take longer.
The DynaFS ignition was designed to work best with the stock coil, coil wire, plug cap, and spark plug. Use resistor type
spark plugs ONLY. Use the stock resistor style spark plug cap.
This kit includes: DynaFS ignition and instruction sheet. This is a complete kit, and includes everything needed to install
the ignition.
Installation
1)
Turn ignition key off, and for safety, remove the battery negative (-) cable whenever attempting electrical
work or welding (this kit does not require welding). Locate the stock ignition box, it is mounted under the
fender on the right side of the quad.
2)
Unplug the stock ignition, taking care not to damage the harness connectors. There is a small tab on each harness
connector that must be pushed in to unplug it. Remove the stock ignition from the bike. Keep the stock ignition in
a safe place - it may be required for troubleshooting.
3)
Place the Dyna ignition in the stock ignition mounting location. Plug the Dyna ignition in.
Calibration
The Dyna FS ignition is preprogrammed with a performance curve, based off of the stock curve. The final timing has been
increased 7°.
Use of this ignition may require rejetting of the carburetor to supply more fuel to maximize performance gains. If you are
unsure of this tuning process, the services of a competent mechanic should be employed. Do not operate the engine in a
lean condition for extended periods or damage may result.
This ignition will allow the engine to rev to a higher RPM than what it has before. Stock rev limit is 8,700rpm. The DFS
rev limit is pre-programmed to 9,700. Because the rev limit is increased, the performance limits of other engine parts
(valvetrain for example) may be found. It may be necessary to replace these parts for best engine performance. Consult
with an engine builder for answers on what works best for your engine.
Note: The reverse limiter is completely defeated (constant override). The belt reset indicator not applicable.
The drive belt should be inspected per owners manual.
Troubleshooting