Two Brothers Racing Kawasaki Teryx 750 Dyna FS Ignition - Manual (Page 4)

DFS
4 wires terminated with
female bullet connectors
3-position connector for
Curve Selector Switch
4-position connector for
PC/Laptop programming
PURPLE = Two-step/low-side Launch Rev Limiter, requires a seperate switch (not included). Ground this
wire to activate the limiter. Use programming software to adjust the launch rpm.
GREEN = Tach output, 1 pulse per rev, 12V
BLUE = Programmable Speed Switch, 2 AMP MAX
(referenced as "RPM Switch 1" in PC software)
WHITE = Programmable Speed Switch, 2 AMP MAX
(referenced as "RPM Switch 2" in PC software)
NOTE1: White and Blue power switches can be programmed individually or together. Can be used to turn
on a shift light, or activate a small solenoid, or switch a Bosch style relay for even heavier loads.
NOTE2: The ignition will ground the White or Blue white inside the CDI when the pre-programmed RPM
is achieved.