Two Brothers Racing Polaris Ranger RZR-S Dyna FS Ignition User Manual
Page 2
Calibration
The DynaFS is pre-programmed with a single performance advance curve, +4° over stock, and a 7,000 RPM rev-limit. A quicker
throttle response and increased power over the stock curve is achieved. For other advance curve information, see the CurveMaker
software. This ignition will allow the engine to rev to a higher RPM, and is adjustable to 10,000 RPM max by using the
CurveMaker software. Because the rev limit is increased, the performance limits of other engine parts (valve train, piston or
crankshaft, for example) may be found. It may be necessary to replace these parts for best engine performance. The DFS9-3 is
shipped from Dynatek with 0% adjustments to all of the fuel injection settings. For more information on fuel settings, see the
section on Using the DRSP-1 Remote Programmer.
Picture 1: Crankshaft Position Sensor connector Picture 2: Throttle Position Sensor connector
Located under transmission on left side of RzR Located behind air filter
Picture 3: Injector connectors
with
Intercepts Picture 4: Ignition Coil
Located behind rear service panel Located behind rear service panel
DYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com