Two Brothers Racing Front Fork Springs Honda CRF/XR50 User Manual
Front fork springs
Two Brothers Racing
Front Fork Springs
We recommend that this performance part be installed by a qualified
motorcycle technician. If you have any doubts as to your ability to install
this performance part, please consult with your local motorcycle dealer.
Read all instructions first before starting installation. Make sure the
motorcycle and exhaust system are completely cool before starting the
installation. Also, make sure the bike is secure on a centerstand or
ideally a service lift during installation. Be sure to save all stock
components for possible use later.
Two Brothers Racing products are intended for closed course competition purposes only, and therefore are sold
“as is” without warranty. Two Brothers Racing specifically disclaims any warranties of merchantability or fitness
for a particular purpose and disclaims all responsibility for consequential and incidental damages or any other
losses arising from the use of these products or parts.
1. Make sure the bike is completely cool before starting the
installation. Make sure the bike is secure on a
centerstand or ideally a service lift.
2. Using a 5mm Allen wrench, remove the stock fork guards.
3. Using 14mm and 19mm wrenches, remove the front
wheel and remove the front axle.
4. Loosen the wing-nut on the bottom of the front-brake
assembly, as shown. Make sure not to lose the spring,
which is likely to bounce away somewhere if you're not
5. Remove the brake cable from the left fork leg.
6. Remove the front-brake cable from the front-brake lever.
7. Using a 14mm wrench, loosen or remove the bolts from
the top of each fork leg, as shown above. As you loosen
the bolts, you may have to hold the lower fork leg
because it can turn with the bolt.
8. Remove the rubber boot that sits in the junction between
the lower and upper fork legs, then use a rag to clean
out the dirt and grease inside the bottom of the top fork
leg. After that, use the snap-ring pliers to remove the
circlip from inside the area you just cleaned out. The rest
of the fork and its internals will come out with the circlip.
...continued on page 2
IMPORTANT - PLEASE READ CAREFULLY
1 of 3