Two Brothers Racing Honda XR50R - Manual (Page 2)

Remove the star shaped piece by removing the 10mm headed
bolt.
Slide the shaft assembly completely out.
5. Remove the snap ring from the kickstart shaft with snap ring
pliers. Remove the kick start spring assembly. Note oriention
of this piece, you may wish to practice installation of this piece
before proceeding as this will make it easier to do so later on.
6. Using an impact wrench remove the flywheel nut. If you do not
have an impact wrench you can use the Rotor Holder (# 010-
9-01-05). Remove the flywheel using the Takegawa Flywheel
Puller (# 010-9-01-03) or equivalent.
7. Remove the left side engine cover. Remove the magnet
assembly (left side of.
8. Remove the two phillips head screws from the cam chain inner
cover. These screws are pretty tight so you may have to use
an impact driver to break them loose. Remove the screws and
the cover.
XR50R 5 Speed Transmission Instructions.qxd PAGE 2
Before
After