Two Brothers Racing Honda XR50R - Manual (Page 4)

16. Reinstall the 10mm shfit drum bolt and rubber cover. This will
keep the transmission in place.
Remove the shift detent piece.
17. Reinstall the kick start spring assembly and check for proper
operation by installing the kick starter and pushing it down as if
you were kicking it. Make sure it returns after it is pushed
down and that it works properly.
Your new 3 speed has a new shift shaft supplied so you do not
have to complete this step, but you will have to use the sup-
plied shifter. The stock or aftermarket shifter will not work
with the supplied shift shaft you will have to use the new
shift inconjuction with the supplied shift shaft.
If you wish to use the stock or aftermarket shifter you must
complete the following steps. Before installing the shift shaft
assembly you will need to trim it. Cut just beyond the welded
area (be sure NOT to cut the weld). Do your cutting BEFORE
installing the shiftshaft assembly. The outside of the cut must
be flush with the engine case. Use a straight edge to make
sure its flush.
Install the detent arm in the reverse order you disassembled
them. Check for proper operation by spinning the shaft by
hand, it should spin smoothly.
Now you are ready to install the clutch (# 010-3-01-2632).
XR50R 3 Speed Transmission Instructions.qxd PAGE 4
STOP-Read step 17 before cutting!!!