Cisco 1503 - Manual (Page 25)

Using Your Hub Software 3-25
System Information Commands
System Information Commands
Use the commands in this section to display general information about the hub and the stack
of hubs.
show system information
Syntax: show system information
Mode: Guest
Description: Displays system information as shown below:
Hub> show system information
System description: Cisco Stackable Ethernet Hub
System up time: hour, 56 minutes
System name: Stack 1
System contact: Mike
System location: Software Group
Command Display Definitions
• System description—Hub model.
• System up time—Length of time that the management agent inside the hub
has been running.
• System name—Name of the hub, configured with the system name
command.
• System contact—Name of the person responsible for the hub, configured
with the system contact command.
• System location—Where the hub is located, configured with the
system location command.