Cisco 1503 - Manual (Page 31)

Using Your Hub Software 3-31
Management Configuration Commands
SNMP Communities Commands
Use the commands in this section to configure the SNMP community strings. These strings
are used by the network management software to access the Micro Hub 1503.
show snmp communities
Syntax: show snmp communities
Mode: Administrator
Description: Displays information about all of the configured community strings. Following
is example output from this command.
Hub> show snmp communities
Index Community Name Access Right Status
--------------------------------------------
1 public read/write enabled
2 private read only enabled
3 read only disabled
4 read only disabled
Command Display Definitions
• Index—Index number of the community string.
• Community Name—Name used for management access. Can be up to 20
alphanumeric characters.
• Access Right—Management access setting: either read/write or read only.
• Status—Community string status: either enabled or disabled.