Alert signal lamps, Ready-light blinks, Note – Nikon 58-104 User Manual
Page 39: Moisture alert light blinks
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Alert Signal Lamps
A warning is indicated when any of
the lamps in the illustration starts
blinking. Look up the cause of the
problem below and follow the
procedures given to fix it.
Ready-light blinks.
If the exposure is not suffioient when the
flash is fired at full output, the SB-104’s
ready-light blinks for about three seconds
to alert you immediately after the flash is
fired in TTL mode. (The ready-light in the
viewfinder will also blink.)
—In this event, reduce the distance between
the camera and the subject, or select a
smaller f-number.
♦Note
Flash power may vary due to surrounding
conditions — with unusually dark subjects,
for example — even though flash shooting
distance settings are the same. A warning
may thus appear if the subject is at the far
end of the flash shooting distance range but
still within it.
Moisture alert light blinks.
This alert indicator blinks when water has
entered the battery chamber. Operation of
the SB-104 stops automatically.
—Bring the Speedlight to a Nikon service
center to have it checked.