Caution, Notes – Nikon 58-104 User Manual
Page 49
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
Turn ON the SB-104’s power switch,
• and check to be sure that the ready-
light is lit.
The shutter is released each time
' another speedlight fires, and the
SB-104 mounted on the camera also
fires at the preset mode.
• Caution
If there are other people in the area firing a speedlight, it may cause
your Speedlight to fire also.
♦Notes
♦It is recommended that you use a tripod for this operation unless you
have someone to assist by holding the slave SB-104 and Nikonos RS.
♦Underwater Camera Slave (cordless remote photography) when
another speedlight (activating a shutter release operation) and the
SB-104 are facing each other is possible within a distance of 10 meters
(32.8 feet).
♦If the flash from the other speedlight (activating shutter release
operation) is not detected by the sensor on the SB-104, the SB-104 may
not fire. Check to be sure the flash fires properly before using it.
♦Battery power consumption of the SB-104 when set for cordless remote
operation is as follows:
With standby switch ON: Equivalent power required for one manual full
output is consumed in approximately six hours.
With standby switch OFF: Equivalent power required for one manual
full output is consumed in approximately 10 minutes.
49