Nikon 58-104 - Manual (Page 50)

Flash Slave
The SB-104 can be used as a flash
slave without releasing the camera’s
shutter. When It senses the light
from a master flash, It fires simulta­
neously, providing additional light for
exposing the photograph. Because
these Speedlights are not connected
by a cord, more than two can be
used to create special lighting
effects.
■ Important
An SB-104, SB-101, SB-102, or SB-103 can be
used as a flash activating unit.
1 Set the function selector on the slave
unit to [V] “flash slave” mode.
—When the power switch is ON, you cannot
set the function selector switch. Turn OFF
the power switch.
I Set the flash mode selector on the
slave unit to either
“ m
Full,”
“ m
1/4,
or “ m 1/16.” (Manual)
Set the output to the desired flash
power as a fill-ln light.
Determine the correct flash output
from the camera’s aperture value
and the distance between the
subject and the Speedlight.
is~wrg"
L
C3
S
iS
• O 0
-FULL »1/4 »1/16 um
/
filfl#
OFFo
\
A
w n n n n n f l n n f l / K I f l n f l n j - f l -
50