4 e check battery power, Rii a set the shutter speed dial to ‘‘a, For automatic operation) – Nikon fe2 User Manual
Page 13: Basic operation, Continued
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BASIC OPERATION
—continued
Le.
4 e Check battery power.
While looking through the viewfinder after switching
the exposure meter on, if the black meter needle swings into the
shutter speed scale range, this indicates that the exposure
meter is working properly.
Notes:
1) When the shutter speed dial is set at B (Bulb) or M250 (1/250 sec.), the
black meter needle doesn’t move: therefore you cannot check the
batteries. Be sure to set the dial to another position. If the black meter
needle still doesn’t move, either the battery is improperly installed
(in which case you should install it properly) or battery power is not
sufficient (in which case you should change the battery).
2) You cannot check the battery power until the frame counter reaches
••
1
."
□
rii A Set the shutter speed dial to ‘‘A”
(for automatic operation).
Rotate the shutter speed dial until the "A” is opposite the shutter
speed/mode index The built-in locking mechanism ensures
that the dial cannot be accidentally shifted from the "A” (auto
position) during shooting.
Note:
The Nikon FE2 camera has one more shooting mode besides
aperture-priority auto exposure: manual operation. For details about
shooting in this mode, refer to pages 25
—26.
12