Detex V50 EE - Manual (Page 8)

L
2
Type
Max Cut-Off
36" Unit
Length (L)
48" Unit
6 in
PRECAUTIONARY NOTE:
NOTE:
1. See "EE ELECTRICAL OPTIONS" before reinstalling filler plate.
2. Be careful when installing fillerplate assembly not to damage wires.
1
See View A, B, & C above
Remove endcap, endcap bracket & fillerplate
subassembly.
Disconnect 12 pin connector, 6 pin connector
and battery
Re-connect in the following order:
1) Battery,
2) 12 pin connector (view A),
3) 6 pin connector (view B).
Install fillerplate subassembly
& endcap bracket.
Install mortise cylinder
with hex nut provided
INSTALLING MORTISE CYLINDER
Dogging lever should be in "ON"
(CCW) position before sliding
back into extrusion
Use optional cylinder collar
(Detex p/n: ECL-1595) when
installing 7-pin
mortise cylinder
2
(1) Move placement of
spacers to match length
of cylinder used to allow
smooth rotation of cam.
2) All cylinder spacers
must be used, either
on top or bottom
cannot be
cut down
Slide endcap assembly
onto extrusion
Protect wires
during cutting
Cut fillerplate and
extrusion to desired
length CAUTION:
Check device and door
frame clearance. If no
cut-off needed, proceed
to MORTISE CYLINDER
INSTALLATION
Electrified
Model
CAUTION:
Tighten with hand tools only.
Do not overtighten.
12 Pin Connection
(note: board layout may differ slightly from layout shown)
View B
6 Pin Connector
View A
RE-INSTALL FILLERPLATE
3
MORTISE CYLINDER INSTALLATION
CHECKING FOR DEVICE CLEARANCE
(Cut-Off procedure if required)
Secure with tape
1
104832 Page 8