EFCO 8800 Series Assembly Instructions Vol.5 - Manual (Page 4)

Series 8700 / 8800 Unitized Curtain Wall Assembly Instructions - Volume 5
Table of Contents
SECTION PAGE
Series 8700 / 8800 Unitized Curtain Wall Assembly Instructions - Volume 5
EFCO 2011 Page 4
Volume 5 of 6
25. Captured Vent Unit Glazing at Stack Sill
A. Temporary Glazing Locators…………………………......................................
B. Setting and Caulking Glazing ……………………………………………………
C. Adapter and Cover Installation…………………………………………………..
D. Joint Plug Installation……………………………………………………………...
26. Assembly and Glazing - SSG Vent at Fixed Horizontal……………………………..
27. Assembly and Glazing - SSG Vent at Stack Sill………………………………………
28. Assembly and Glazing - Captured Vent at Fixed Horizontal……………………….
29. Assembly and Glazing - Captured Vent at Stack Horizontal……………………….
30. Hardware Mounting On Unit Assembly………………………………………………..
31. Hardware Mounting On Sash…………………………………………………………….
32. Mounting Vent Assembly Into Unit Assembly………………………………………..
45
46 - 47
48 - 52
53
54 - 58
59 - 63
64 - 68
69 - 73
74 - 75
76 - 85
86 - 90
Volume 6 of 6
33. Shadow Box Assembly
34. Shadow Box Installation
35. Shadow Box Insulation Installation
36. Back Panel Installation
37. Back Panel Insulation Installation
38. Final Cleaning
Note: Assembly Instructions are provided as a supplement, and should be used in conjunction with the approved shop drawings.
Minimizing Condensation
Note: Please reference EFCO's "Understanding Condensation" brochure which can be obtained through your EFCO
representative.
Condensation will form on any surface when unfavorable conditions (interior temperature and relative humidity and
exterior temperature) are present. When the formation of excessive condensation is a concern, it is highly recommended that a
design professional is utilized to perform an analysis of the shop drawings to recommend the best possible installation methods.
Please contact your EFCO representative for information on EFCO's Thermal Analysis Services.
Many current installation practices lead to an increase in the possibility of the formation of condensation. Though not all
inclusive, the list of examples below illustrates conditions under which condensation is likely to occur:
1. Bridging system thermal break with non-thermally broken metal flashing or lintels that are exposed to the exterior
2. System exposure to cold air cavities
3. Interior relative humidity levels not maintained at recommended levels, see EFCO’s “Understanding
Condensation” brochure
4. Inadequate separation between system and surrounding condition at perimeter
5. Product combinations during the shop drawing stage that result in bridging thermal breaks
of one or all products involved