Kontron AT8404 CLI - Manual (Page 185)

AT8404 Quality of Service (QoS) Commands
Page 3 - 11 AT8404 CLI Reference Manual
mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom ethertype value in the range of 0x0600-
0xFFFF.
3.3.4 match any
This command adds to the specified class definition a match condition whereby all packets are considered to belong
to the class.
3.3.5 match class-map
This command adds to the specified class definition the set of match conditions defined for another class. The
<refclassname> is the name of an existing DiffServ class whose match conditions are being referenced by the
specified class definition.
Note: This command is not available on the Broadcom 5630x platform.
Format match ethertype {<keyword> | custom <0x0600-0xFFFF>}
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format match any
Mode Class-Map Config
Ipv6-Class-Map Config
Default none
Format match class-map <refclassname>
Mode Class-Map Config
Ipv6-Class-Map Config
Note:
• The parameters <refclassname> and <class-map-name> can not be the same.
• Only one other class may be referenced by a class.
• Any attempts to delete the <refclassname> class while the class is still referenced by any <class-
map-name> fails.
• The combined match criteria of <class-map-name> and <refclassname> must be an allowed
combination based on the class type.
• Any subsequent changes to the <refclassname> class match criteria must maintain this validity, or
the change attempt fails.
• The total number of class rules formed by the complete reference class chain (including both
predecessor and successor classes) must not exceed a platform-specific maximum. In some cases,
each removal of a refclass rule reduces the maximum number of available rules in the class definition
by one.