Kontron AT8404 CLI - Manual (Page 291)

AT8404 Management Commands
Page 5 - 15 AT8404 CLI Reference Manual
5.7 User Account Commands
This section describes the commands you use to add, manage, and delete system users. FASTPATH software has
two default users: admin and guest. The admin user can view and configure system settings, and the guest user
can view settings.
5.7.1 users name
This command adds a new user account, if space permits. The account <username> can be up to eight characters
in length. You can use alphanumeric characters as well as the dash (‘-’) and underscore (‘_’). You can define up to
six user names.
5.7.1.1 no users name
This command removes a user account.
5.7.2 users name <username> unlock
Use this command to unlock a locked user account. Only a user with read/write access can re-activate a locked user
account.
5.7.3 users passwd
Use this command to change a password. Passwords are a maximum of 64 alphanumeric characters. If a user is
authorized for authentication or encryption is enabled, the password length must be at least eight alphanumeric
characters. The password is case sensitive. When you change a password, a prompt asks for the old password. If
Note: You cannot delete the admin user. There is only one user allowed with read/write privileges. You
can configure up to five read-only users on the system.
Note: The <username> is not case sensitive when you add and delete users, and when the user logs
in. However, when you use the <username> to set the user password, authentication, or encryption, you
must enter the <username> in the same case you used when you added the user. To see the case of
the <username>, enter the show users command.
Format users name <username>
Mode Global Config
Format no users name <username>
Mode Global Config
Note: You cannot delete the “admin” user account.
Format users name <username> unlock
Mode Global Config